Outdoor Headquarters

 
 HACKER SAFE certified sites prevent over 99.9% of hacker crime.

 

Here are a few tips to make sure you get the correct size in your Lacrosse Boots or LaCrosse Waders.

All LaCrosse boots and waders have been designed to combine comfort with maximum durability. To fit well, a boot needs to hold the foot securely and comfortably. It needs to be long enough so as not to over-crowd the toes, and wide enough to accommodate the foot and the usual pair of socks. It also needs to hold the heel securely in place to prevent slippage, the most common cause of blisters.

Boots are made with two size indicators: size and width. Size indicates how long the boot is from the heel to the toe; width from side to side at the ball of the foot.

BURLY®
All Burly® rubber knee boots run a size larger than what you normally wear in an athletic shoe and are available in whole sizes and one width only. It's recommended that half sizes order the next full size down. For example, if you wear a 10 1/2 you should purchase a size 10.

Burly® rubber knee boots were designed to be Ankle-Fit to keep them from being sucked off in mud or muck, which helps to reduce fatigue. To help them go on easier make sure to wear quality socks. A 100% cotton sock can make it difficult, so avoid this when ever possible, and utilize socks with moisture management capabilities such as polypropylene. Using a boot jack is the best way to take your Ankle-Fit Burly® boots off.

ALPHA BOOTS
The line of Alpha rubber-clad neoprene boots have been designed to fit your foot like a sock. The snug fit around your foot and in the toe box give the Alpha boots an "ankle-fit" effect and will minimize heel slippage and reduce fatigue. If you prefer having extra room in your boots, you should order a size larger than you would in an athletic shoe. However, the proper Alpha fit is to order your actual shoe size. Since Alpha boots are only available in whole sizes and medium width, it's recommended that half sizes order the next full size available. For example, if you wear a 10 1/2 you should purchase a size 11.

WADERS
To achieve a proper fit, refer to the charts below and select the size corresponding to your body measurements. Waders should be ordered based on shoe size, but a more accurate fit can be achieved by choosing Regular, King or Stout. Neoprene waders can accommodate a range of sizes due to the high degree of stretch.

Shoe Size: Waders are available in whole sizes and one width only. It is recommended that half sizes order the next full size listed on the chart. For example if you wear a 10 1/2 you should purchase a size 11.

Inseam: Measurement of individual from crotch to floor.

Outseam: Measurement of individual from armpit to floor.

Measurements listed in the size charts are body measurements, and are not the dimensions of the product.

 
NEOPRENE BOOTFOOT WADERS
Boot Size Inseam Outseam Chest
7 Regular 31 45 42
8 Regular 31 45 42
9 Regular 32 47 45
9 Stout 30 45 47
10 Regular 32 47 45
10 King 33 48 47
10 Stout 30 45 47
11 Regular 33 49 48
11 King 34 50 50
11 Stout 31 47 50
12 Regular     33 49 48
12 King 34 50 50
12 Stout 31 47 50
13 Regular 34 51 50
13 King 35 52 52
14 Regular 35 53 50
14 King 36 54 54
15 Regular 35 53 52
15 King 36 54 54

 
NON-NEOPRENE BOOTFOOT WADERS
Boot Size Inseam Outseam Chest
7 Regular 31 51 40
8 Regular 32 52 41
9 Regular 33 52 41
10 Regular 34 54 43
11 Regular 34 56 44
12 Regular 35 56 45
13 Regular 35 57 46
14 Regular 36 57 46


 
YOUTH WADER CHART
Size Inseam Outseam Chest Waist
13 22 33 29 28
1 23 35 30 29
2 24 37 31 30
3 26 39 33 32
4 27 41 35 34
5 27 44 37 36
6 28 47 39 38
7 29 49 41 40
8 30 50 43 42


PAC BOOTS
Traditional pac boots, like the Ice King™, will fit more generously than your typical boots and shoes. In cold conditions this allows the air to circulate so your feet stay warmer. Traditional molded rubber shell pac boots are available in whole sizes and one width only. To achieve the proper fit, it's recommended to order the size you would normally wear, and the next available full size if a half size is needed. For example, if you wear a 10 1/2 you should purchase a size 11. The overall fit can be adjusted by wearing a heavier or lighter sock.

PRECISION FIT TECHNOLOGY™ BOOTS
Just like their name PFT™ pac boots are designed to fit more precise than a traditional pac because they're built on a last like a leather lace-up. This makes PFT™ boots the only pacs available in whole and half sizes and medium and wide widths. The design also allows us to build Thinsulate™ Insulation into the boot so you won't need to pile on the extra socks for a better fit or more warmth. PFT™ boots have an athletic fit and feel to them so it's recommended to buy the size you would normally wear in a leather lace-up boot. For example, if you wear a 10 1/2 wide you should purchase a size 10 1/2 wide.

OVERSHOES
LaCrosse rubber overshoes fit size-for-size over traditional plain toe and safety toe leather work boots. Slush molded overshoes, like the Gator and Packer are available in small to double extra large.

Size conversion for overshoes: X-Small = Men's size 3-5, Small = Men's sizes 6-8, Medium = Men's sizes 9-10, Large = Men's sizes 11-12, X-Large = Men's size 13-14, XX-Large = Men's sizes 15-16
 
Daybed Covers Duvet Covers Futon Covers
For A Complete Selection Of Daybed Covers, Futon Covers, Duvet Covers and Accessories, Visit our sister company at Home Headquarters. 		HOME • ABOUT US • CUSTOMER SERVICE • PRIVACY • RETURNS • SHIPPING
 ONLINE CATALOG
Outdoor-Headquarters
7525 Highway 273
Blakely, GA  39823
IN USA Call Toll Free 1-866-571-9343
Credit Cards Accepted
  © 2002-2008 BSLR Enterprises, Inc. all materials within this site may not be reproduced in any form without written permission. For comments or questions about this site, please e-mail us.